The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We are busy working through our list of maintenance items – this past weekend (the 28th & 29th of February and the 1st of March), we picked up our new muffler & repaired header, we reinstalled the refurbished steering rack, we cleaned the springs and the perch mounts, we installed the four rebuilt shocks, we vacuumed the floor pan, we reinstalled the recharged fire suppression system, we reinstalled the transmission that was serviced at Vallis Motor Sport, we washed the half shafts & began building them for installation, we installed the seat, installed a new oil temperature sensor,  and we heat shrunk some critical electrical cables.   All in all a very busy and successful weekend. Here are some pictures of the work we completed.

Stay tuned to our Facebook page and to our website for ongoing updates.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 

And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We are busy working through our list of maintenance items – this past weekend (the 25th & 26th of January), we picked up our newly finished spare engine for the engine builders last week, we reinstalled the carbs and intake manifold on the engine in the race car, we scuffed the brake rotors for the new brake pads, we removed and replaced critical rod ends and we began the final finishing of the repaired front nose. Here are some pictures of the work we completed.

Stay tuned to our Facebook page and to our website for ongoing updates.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 
​
And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We are busy working through our list of maintenance items – this past weekend (the 18th & 19th of January), we removed the carbs and intake manifold for testing later this week, re-taped the seat, mounted an additional AiM channel expansion module, detailed the dash with blue pin striping and repaired a crack in the nose as well as the front wing mounting points.  Here are some pictures of the work we completed.

Stay tuned to our Facebook page and to our website for ongoing updates.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 
​
And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We are busy working through our list of maintenance items – today (the 27th of December), we repaired removed the trans axle assembly for service at Vallis Motor Sport, removed the half shafts for cleaning and repacking, painted the dash with semi-gloss black (to reduce the glare from the prior very shiny aluminum), removed the exhaust header (we found a crack that will need to be welded) and began working on re-taping the seat insert.  Here are some pictures of the work we completed.

Stay tuned to our Facebook page and to our website for ongoing updates.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 
​
And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We are busy working through our list of maintenance items – today (the 21st of December), we repaired the left rear bearing carrier (the stub axle was loose inside the carrier housing), installed a remote oil pressure sender and prepared the front wing for some fiberglass repair.  Here are some pictures of the work we completed today.

Stay tuned to our Facebook page and to our website for ongoing updates.
 
As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 
​
And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

​The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We busy working through our list of maintenance items – this past Sunday (the 15th of December), we installed a new oil catch can, installed new brake pads and lubricated the brake pad slider pins, disassembled the front nose/wing assembly, re-riveted the rear wing reinforcement and we took an inventory of the rod ends that we will be replacing during the next 30 days.  Here are some pictures of the work we completed on Sunday.

Stay tuned to our Facebook page and to our website for ongoing updates.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 
​
And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

​The STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda has been in the shop at the Subject Motorsports worldwide headquarters here in Burlington since October.  We have a very long list of items to complete before the 2020 season including: shock absorber service, steering race service, transmission service, CV joint service, chassis inspection, recharge the fire suppression system, installation of shock absorber data system, brake service, cleanup and repair of the bodywork, and repair the rear wing.  We began working on the 8th of December, here are some pictures of the work we have performed today.

We suggest that you stay tuned to our Facebook page and to our website for ongoing updates.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. 
​
And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track allows us to continue to do the racing thing……….

Photos from our race weekend at the SVRA 2019 U.S. Vintage Grand Prix at Watkins Glen International

Since our most recent race weekend with the SVRA at the Brickyard Vintage Racing Invitational, we have been preparing the STANMECH Technologies, Good Cars Only, Gabo Solutions #77 Formula Mazda for the last race of our season with the SVRA at the U.S. Vintage Grand Prix at Watkins Glen International during the 1st full weekend in September. Here are some pictures of some of the cleanup work we have performed over the last few days here at Subject Motorsports worldwide headquarters in Burlington.

The car will be off to Vallis Motor Sport during the last week in August for some finishing touches in preparation for last race of the season.

As always, a very big thank you to our sponsors; STANMECH Technologies, Good Cars Only, Gabo Solutions, and to Bill and Shirley Vallis of Vallis Motor Sport for their excellent maintenance and track side support. Stay tuned to our Facebook page and to our website for ongoing updates.

And last, but certainly not least, we want to thank our long suffering and tormented family which follows us from race track to race track and allows us to continue to do this crazy racing thing……….

​Photos from our race weekend at the SVRA Brickyard Vintage Racing Invitational at Indy